The surface of the heat pad is 90 to 100°F (32 – 38°C) without any temperature control in a home environment that is kept at 60 to 70°F (15 – 22°C). However, it is recommended to always use a temperature control. For an accurate measurement of the surface temperatures, wait for about an hour after power is applied.
Under the same circumstances, heat pads measuring 2 x 3′, 3 x 3′, 3 x 4′, and 3 x 6′ operate between 80 and 90°F (27 and 32°C). The precise surface temperature of the heat pad is affected by the interior air temperature in the house or enclosure and the type of flooring material. Osborne Heat Pad Controls are suggested for optimum performance and economy because they were created specifically for heat pad control.
No. Coverings of any sort are not recommended or needed. The heat pad will typically operate inefficiently and improperly if it is covered with bedding materials or residues. The Stanfield Heat Pad is robustly made for direct contact with young animals, doing away with the need for bedding and the associated expense and labor of maintaining bedding materials.
The Stanfield Heat Pad cannot warm a pet enclosure because it doesn’t produce enough heat. Due to the fact that it offers a warm sleeping area, it draws pets and other young animals. Chilling is possible if the air temperature falls too low, especially if the laying area allows drafts.
Animals typically discover the heat pad on their own while examining their surroundings. Some animals need the additional radiant warmth of a heat bulb right away following birth to help dry the young.
Stanfield Heat Pads work well on all floor types. Make sure there is adequate drainage on solid concrete floors to prevent water or urine from collecting beneath the heat pads. Long-term contact with these liquids can reduce the heat pad’s useful life. Osborne Heat Pad Controls are especially suggested for adjusting the temperature to match the type of floor on plastic or wood floors.
No. The Stanfield Heat Pad is made to emit heat continuously. Because it only samples the temperature in a very small area of the heat pad, an internal thermostat is not a trustworthy way to regulate heat pad temperature. The thermostat for such a heat pad is inherently less robust than the heat pad itself. For dependable and affordable heat pad temperature control, Osborne Heat Pad Controls are advised.
Puppies, piglets, reptiles, turtles, and tortoises are just a few of the many animal species and applications that Stanfield Heat Pads can be used for. Inform Osborne Customer Service of your application so they can assist you in selecting the model that will best meet your needs.
By preventing accidental entry by adult animals, fastening heat pads to the floor, draft barrier, or wall ensures proper operation and safety. Use the predrilled holes to secure the heat pad or add holes at the pre-dimpled locators. On solid concrete, use expansion bushings and screws. Apply a bead of caulking compound around the outer edge of the heat pad before attaching it to the floor to prevent moisture and residue from accumulating under it.
Yes. Within the one-inch (25 mm) border area, additional anchor holes can be drilled at the pre-dimpled locations.
Yes, position the heat pad so that animals, especially adult animals that might chew or step on it, cannot access the power cord. Osborne sells specialized cord protectors, but plastic conduit can also be used. To stop rodents from using the conduit as a secure hiding place, make sure it fits snugly around the cord. Such rodents could damage or destroy the power cord insulation.
Stanfield Heat Pads don’t need any special setup in addition to standard electrical device usage procedures. Always use a properly fused electrical system. To prevent electrical shock in the event that a power cord or heat pad is accidentally damaged, make sure that all metal in contact with the heat pads has a positive ground. It is strongly advised to use a Ground Fault Interrupting (GFI) circuit connected in series with the heat pads, especially when doing so on metal floors or in wet environments. Ask a certified electrician to inspect your setup for safety.
The Stanfield Heat Pad is designed to minimize power consumption. The low power rate is a compelling argument in favor of heat pads over pricey substitutes like heat bulbs. Contact Osborne Customer Service for more details so you can compare alternative products to Stanfield Heat Pads. You will learn that Stanfield Heat Pads are the only method that is effective.
Alternative designs may have slight variations in efficiency and heat distribution, but none of these variations are substantial enough to justify the initial cost, safety risks, or reliability issues associated with these designs. Our 40 years of success with millions of animals after evaluating numerous alternative designs demonstrate that the Osborne design is the most dependable, long-lasting, secure, and cost-effective option. Let us give you the accurate details.
Yes. For electrical heaters for animals, Stanfield Heat Pads are approved to UL, CSA, CE, IEC, and PSE standards. Additionally, they are flame-resistant and non-burning, which prevents electrical fires. Stanfield Heat Pads easily pass the demanding CSA water immersion test because they are made of nonporous fiberglass-reinforced thermoset plastic that is water-resistant.
The Stanfield Heat Pad’s thin profile makes it very difficult to damage if fastened securely. When working with an adult animal and a heat pad, extra caution and attention may be required. Always protect the power cord, especially from adult animals.
The power cord can be replaced if it is damaged for a small fee. Clean and return the heat pad, freight prepaid. Your name and address should be prominently printed on the heat pad. Contact Osborne Customer Service for complete instructions. Any licensed electrician can extend the power cord or “hard-wire” it through a junction box.
Animal behavior is the best thermostat. Check the heat pad if the animals leave it to lie elsewhere because it might be too hot or too cold. If the temperature is too low, turn on a space heater or raise the Osborne Heat Pad Control’s temperature setting. The heat pad is too warm if the animals lie around the edge of it rather than directly on it or if they urinate there. To remedy this, try one of the following options:
The surface texture strikes a good balance between smoothness (for simplicity in cleaning and to prevent abrasions) and roughness (to provide foot traction and prevent young animals from developing irksome leg issues). Young animals’ footing is improved by keeping the heat pad as dry as possible.
Osborne has provided a one-year warranty against manufacturing and material flaws on the heating element for 40 years. The user is responsible for protecting the power cord, but our reinforced power cord bushing and conduit are very robust. For information on our warranty or to obtain a copy of our warranty statement, contact Osborne Customer Service at 1-800-255-0316.
If the power cord is damaged, it can be replaced for a small fee. Clean and return the heat pad, freight prepaid. Your name and address should be prominently printed on the heat pad. Contact Osborne Customer Service for complete instructions. Any licensed electrician can extend the power cord or “hard-wire” it through a junction box.
If your dog lacks fur:
Not all breeds were endowed with the Siberian Husky’s thick winter coat to keep them warm. Heated beds are beneficial for thin, small, or hairless dogs. Thanks to their warm beds, they will be able to stay warm even during the coldest winter nights.
Are Dog Heating Pads Safe?
Heating pads are completely safe when used properly, according to Brayshaw, but you must be very careful. To avoid “direct heating pad to skin or fur contact” that could burn your dog, cover the heating pad when using it on your dog, suggests Brayshaw. Keep in mind that “if it is too hot for you, it is probably really too hot for your dog,” and frequently check the temperature of the pads. Last but not least, give your dog the option to leave the pad whenever they want. According to Brayshaw, your dog is the best judge of what is comfortable for them and when they become too hot or cold. “You ought to give them the choice to switch from or to a heating pad.” Dogs with mobility issues like arthritis may require additional assistance getting on or off a heating pad. When using heating pads, it’s important to check on these dogs more frequently.
Clubs Offering:
Most dog owners purchase heated beds or pet heating pads for their pets as the weather gets colder in order to keep them warm and comfortable. As your dog ages or if he has health issues that could affect his comfort levels, it’s especially crucial to keep him warm and cozy. The good news is that there are many heated beds available for purchase that can be selected based on your dog’s needs and age. Owners may be hesitant to buy a heated bed for their dog, as they are with many pet products. They might doubt its safety risks or whether it’s even worthwhile to invest in. In actuality, some dogs may benefit from heated dog beds, while others may not need them as much.
FAQ
How long can a dog lay on a heating pad?
It should be applied to the affected area for 15 to 20 minutes. To prevent burns, make sure the heat pack is not too hot (generally between 40 and 45 degrees). Make sure your dog’s skin is only barely warm by checking it. If your older dog doesn’t like it, don’t make them use a heat pack.
Is it OK to let dog lay on heating pad?
Dogs and people react to heat in different ways, so your own heating pad or blanket shouldn’t be used with your pet. Invest in a heating pad designed specifically for dogs, and carefully read the manufacturer’s instructions to understand how it functions and how long your dog can use it without risking injury.
Why does my dog like to sleep on a heating pad?
It’s possible that your dog prefers to sleep in the area where the mat is kept or that he or she enjoys the fact that the fabric retains some of his or her scent.
Can my dog lay on my heated blanket?
Most likely, you have a heated blanket at home that you can use if you get cold. However, because our body temperatures differ, you should never use the same blanket on your dog. Because they operate at low voltage and heat up safely for a dog’s needs, heated dog beds are secure for dogs.